840D系统,同一个程序在加工时有时可以加工,有时出现14800报警:通道％1程序段％2编程轨迹速度小于或等于零.
最佳答案
14800 Channel %1 block %2 programmed path speed less or equal to zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A negative F value has been programmed in conjunction with the G functions G93, G94,
G95 or G96. The path velocity may be programmed in the range 0.001 to 999 999.999
[mm/min, mm/rev, deg/min, deg/rev] for the metric input system and 0.000 1 to 39
999.999 9 [inch/min, inch/rev] for the inch input system.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program the path velocity (geometric sum of the velocity components of the geometry
axes involved) within the limits given above.
Program Continuation: Clear alarm with NC START or RESET key and continue the program.
程序段里没有进给速度F.HUO
提问者对于答案的评价：
谢谢.
原创文章，作者：more0621，如若转载，请注明出处：https://www.zhaoplc.com/plc254451.html
微信扫一扫 
支付宝扫一扫 